Application Instructions For Vinyl:

Acceptable surfaces:

Vehicles

Glass

Metals (Must be painted with a smooth, glossy enamel.)

Vehicles (Must be painted with a smooth, glossy enamel.)

Vinyl (Such as Banners, Canopies, flags, etc.)

Plastic

Fiberglass (Must be painted with a smooth, glossy enamel.)

Other Painted Surfaces (Paint must be smooth and glossy, vinyl will not stick to oxidized, faded, or peeling paint)

Not recommended surfaces:

Cement, Raw Lumber, Oxidized or faded paint, Peeling paint, Rubber, Raw Metals, Oily Surfaces, Plywood or wood in general, Primer Painted Surfaces

These lists are not comprehensive and there are other acceptable and unacceptable substrates than those listed above.

Dry Method - Adhesive Backed Vinyl Application Instructions (RECOMMENDED)

Read all of our directions first!
Clean the surface well to avoid dust and oil under the vinyl.
Without removing the backing, place sign exactly in the position it is to be located.
Hold everything temporarily into place with masking tape.
Step back and see how it looks.
Once applied, it cannot be re-positioned.
Measure twice to assure accuracy, measure from the flat areas on numbers and letters.
Apply a piece of masking tape across the entire top edge, to make a hinge.
Fold the sign back along the tape hinge.
Remove the backing (back side), revealing the sticky side
(Only remove the backing - DO NOT remove the transfer tape - Front Side)
CAUTION: Do not allow the sign to fall freely on the surface
or it will stick there and potentially ruin the vinyl if you try to
remove it.

Hold the sign away from the surface. With a squeegee
(plastic spatula, bondo applicator, etc.) carefully begin to squeegee
down the top 1 to 2 inches along the top edge. Work from the hinge down,
squeegee down and out over the remaining sign area, but be careful not
to trap any air bubbles behind the vinyl.
Remove the transfer tape by slowly peeling it back from the sign.
The sign will remain in place if it has been firmly applied.
If any air bubbles appear, puncture with a pin and squeeze the area to flatten the bubbles.
Tiny bubbles will disappear over time with the heat of the sun.

Wet Method - Application of Adhesive Backed Vinyl

This method makes it easy to put down large graphics with
less air bubbles. Take your time and you will get professional looking
results.
You can use this method as above with a tape hinge by
inserting the following steps after the coordinating symbols. OR You can
"float" the sign on the surface without a tape hinge; this will allow a
small amount of movement for straightening.
Create a Liquid Soapy Water Mixture: Mix 1 1/2 teaspoons of dish soap with 32 oz. of water. Mix in a spray bottle.
Prepare mix before you begin application.
* Spray a liberal amount of soap & water mixture on the
surface to which you are applying the vinyl AND the adhesive side of the
vinyl - first remove the paper backing.
** Squeegee out the water. Allow the water to dry before
removing the transfer tape. MUST let dry for AT LEAST 12 hours in SUN or
use hair dryer to assure the lettering has strongly adhered to the
surface.
CAUTION: In both Dry Method and Wet Method, once the sign
has been applied it cannot be re-positioned. It can be removed by
applying a little heat with a hair dryer AND peeling it away. The sign
is not reusable once it has been removed.